The implement does not reach the desired working depth

The soil is too hard.

  • Draw transverse furrows at the ends of the field.

The working depth is incorrectly adjusted.

  • Adjust the working depth.

The plough bodies are worn.

  • Replace the plough bodies.

The wrong plough body is being used.

  • Use an interchangeable tip.

The disc coulter is set too deep.

  • Set the disc coulter shallower.

The pitch is set too flat.

Not possible for all plough bodies

  1. Park the implement on a level surface in working position.
  2. Lift the implement out of the working position until the plough bodies are lifted from the ground.
  3. Loosen the plough leg bolts 1 on the lower plough body.
  4. If necessary, set a steeper pitch on the plough bodies using the bolts 2.
NOTE

The steeper the plough body, the better the penetration behaviour and the higher the pulling force requirement and wear.

  1. Check that all plough bodies have the same distance from the plough beam.
  2. Tighten the plough leg bolts 1 with 580Nm.
  3. After turning, set the plough bodies on the other side steeper to the same degree.