Coupling the hoeing machine

  1. Open the locking mechanism 1 on the lower link catch hooks.

Enough space must remain between the implement and the hoeing machine so that the supply lines can be coupled without obstructions.

  1. Drive the implement towards the hoeing machine, leaving a sufficient distance.
  1. Route the hydraulic hose lines marked in blue 2 for unfolding and folding the sections of the hoeing machine and for lowering and lifting the support wheels of the hoeing machine through the hose grommet 1 over the sliding frame and fasten with the Velcro straps.

  2. If the hoeing machine is equipped with a manual control unit with steering wheel:

    Likewise, route hydraulic hose lines beige 1 and beige 2 through the hose routing over the sliding frame and fasten them with Velcro straps.
  3. Drive the implement towards the hoeing machine.

  4. To connect the lower link catch hooks to the lower link balls of the hoeing machine:

    Lift the implement from the tractor seat.
  1. Close the locking mechanisms for the lower link catch hooks.
  2. Check whether the locking mechanisms of the lower link catch hooks are correctly locked.
  1. Move the implement up or down so that the upper hole 1 in the top link plate 2 is aligned with the holes of the top link mount of the hoeing machine and the vertical braces of the sliding frame and the hoeing machine are aligned parallel to each other.
  2. Couple the top link plate with the top link pin.
  1. Couple the hydraulic hose lines of the hoeing machine marked in blue onto the tractor.

  2. If the hoeing machine is equipped with a manual control unit with steering wheel:

    Couple hydraulic hose lines beige 1 and beige 2 onto the tractor.

  1. If the hoeing machine is equipped with hydraulically lifting parallelograms and Section Control:

    Couple the wiring harness 1 for the Section Control electronics onto the ISOBUS plug and the hydraulic hose lines marked in green 2 for the parallelograms onto the couplings.

  1. If the hoeing machine is equipped with a camera system:

    Connect the cable for the camera system to the sockets 1 and 2 on the hose routing.

  1. If the hoeing machine is equipped with a manual control unit with steering wheel:

    Couple hydraulic hose lines 1 beige 3 and beige 4 onto the coupling mount.

  1. If the hoeing machine is equipped with a manual control unit with joystick:

    Connect the plug 1 and socket 2 on the hose routing.

  1. If the hoeing machine is equipped with a front tank and band sprayer:

    Couple the hydraulic hose lines marked in red 1 for the pump of the front tank onto the couplings.