Moving the plough bodies into working position

The implement is parked in working position on the plough bodies and parking supports.

NOTE

Before swivelling the plough bodies into working position, set the tilt angle on the right from 90° back to the working value if necessary, Adjusting the tilt angle of the plough relative to the tractor.

REQUIREMENTS

  • Implement in transport position

  1. Unlock the transport lock using the hand lever.
  2. Lift the implement using the 3-point hitch enough so that there is enough ground clearance to swivel the implement.

  3. To swivel the plough bodies into working position,

    Actuate the green tractor control unit.
  4. Swivel the plough body to the right so that the control elements of the wheel are accessible.
NOTE

If necessary, release the transport lock by actuating the green tractor control unit on both sides.