Implement with support wheels is not standing horizontally

The tyre inflation pressure of the support wheels is incorrect

  • Correct the tyre inflation pressure.

The support wheel tyres are worn

  • Have worn tyres replaced.

The support wheels are incorrectly set

  • Align the implement horizontally with the lower link or the hydraulic drawbar.

  1. If the implement is not standing horizontally:

    Check the length of the adjustment spindles.

Default setting: 540mm long

NOTE
If the length of the adjustment spindles is increased, the transport width of the implement increases.
Do not exceed the permissible transport width.
  1. Loosen the lock nuts 1 on the adjustment spindles.
  2. Adjust the inner support wheels first using the hexagonal profile 2.
  3. Adjust the adjustment spindles on all of the support wheels to the same length.
  4. Tighten the lock nut.