Adjusting the pull point

CAUTION
Risk of crushing
During adjustments, keep your hands away from the components of the adjustment centre.

The pull point is adjusted via the threaded spindle 1 such that there is no lateral pull on the tractor. To prevent lateral pull, the landside 2 of the plough body must be aligned with the direction of travel.

The pull point is adjusted after manual adjustment of the working width.

  • If the tractor pulls towards the ploughed side of the field: reduce the threaded spindle length.

  • If the tractor pulls towards the unploughed side of the field: increase the threaded spindle length.

The standard measurements for L are theoretical dimensions and can deviate from the real dimensions.

Teres 200

Teres 200

Teres 300

Interbody clearance

90cm

100cm

100cm

Working width

Standard measurement L

35cm

27,7cm

27,1cm

31,5cm

40cm

25,5cm

25,1cm

29,4cm

45cm

23cm

23cm

27,2cm

50cm

20,4cm

20,7cm

24,9cm

REQUIREMENTS

  • The implement is in working position

  1. Loosen the bolts on the cover.
  2. Take off the cover.
  1. Slightly lift the implement out of the working position.

  2. To relieve the threaded spindle:

    Briefly actuate the green tractor control unit.
  3. Remove the bolt 1.

  4. To adjust the threaded spindle length:

    Turn the setting nut 2.

Use the enclosed wrench.

  1. Tighten the bolt.
  2. Put on the cover.
  3. Fasten the cover with bolts.