The wheel mark eradicator tool carriers are constantly working in the soil horizon.

Due to wear on the rotating tines, the working depth of the soil tillage implement must be corrected. The wheel mark eradicator brackets are too close above the soil.

IMPORTANT
The tool carriers become worn when constantly working in the soil.
Install the wheel mark eradicator bracket at a higher position.

  • To prevent the tool carriers 1 from constantly working in the soil horizon,

    rotate the wheel mark eradicator bracket 2 by 180 degrees.
  1. Release the linch pins and locking pins 4.
  2. Release the linch pin 3.
  3. Hold the wheel mark eradicator 1.
  4. Remove the locking pin 2.
  5. Remove the wheel mark eradicator.
  1. Loosen and remove the nuts for the clamp connection 2.
  2. Remove the wheel mark eradicator bracket 1.
  1. Install the wheel mark eradicator bracket 1 rotated by 180 degrees.
  2. Install the nuts for the clamp connection 2.
  3. After 5 hours of operation, check the bolt connection for tight fit.
  1. Fasten the wheel mark eradicator 1 in the bracket with the locking pins 2.
  2. Secure the locking pins with the linch pins.

  3. To prevent the tool carriers from constantly working in the soil horizon,

    move the wheel mark eradicator to a higher position.
  4. Secure the wheel mark eradicator at the desired position with the locking pin 3.
  5. Secure the locking pin with the linch pin.